Happy Seal

Can't find the pics with the engine mounts installed. . .but 1st one is the 8374 and 2nd is 7670. . .much more room to play with. . .

I'll be back home Thursday and reply on this...I hope it does...

Finally got a manifold that will fit an EFR...Future Fabrications twinscroll with EFR 8374...no wastegate installed yet as the flanges are for Tial instead of Precision...

I tried out the 8374 and 7670 on an HKS bottom mount. Issue with the 8374 was the compressor inlet sits too close to the engine mount and also fouls the oil supply port on the block. 7670 sits much better, will have to use a sharp angle for the intake pipe right off the compressor to clear the mount. I'll dig up some pics and post them later. . .

If you watched the drift live stream I'm the one who got Keiichi drinking at the judge stand haha. . .

Would love to fight a Kangaroo, bonus points for Dingos and Mad Max...#maplebaconinvasion

WTAC 2016 Anyone participating or going to it this weekend? Just flew in from Canada, not sure whats hot/not...

While I haven't driven an EFR RB engine (yet) we've installed one on my friend's FD with stock ports and all bolt ons. . .It's on a base tune right now with 8 psi and it's insane at how quick it spools. . .no delay whatsoever. . .My FD is getting the 9174 treatment in a couple of weeks

You could make it fit, it will look like shit but it's your car. . .I've got 18x11 TE's all the way around with 295's and that's getting close to the limit of the fenders. . .

Define cold. . .

AFAIK, They've only released the 90° housings for the 6258, 6758 and 7163...

Tried a pm, don't think it worked. . .any pictures? Fully functional? Willing to ship to Canada?

Is there anything else wrong with this manifold?

Those were my twins. . .I split the setup (twins/manifolds) and sold it. . . Precision doesn't offer the rb26 specific turbine housings, you can purchase the 4828's without their hotside (-$100), but will have to buy the 707160-5 housings and throw them on the 4828's. . .as far as piping goes my plan was to fab up some hard pipes all the way. . .

Those bumps are there because of the water jackets that are close to it. . .you can remove them but not too much meat. . .there are a few machinists here that have cut the heads up to see exactly how much they can take out. . .as far as power gains I haven't seen anything concrete from this mod alone. . .