Jump to content
SAU Community

ian895

Members
  • Posts

    21
  • Joined

  • Last visited

  • Feedback

    100%

Profile Information

  • Gender
    Male

Profile Fields

  • Real Name
    Lan

ian895's Achievements

Apprentice

Apprentice (3/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. Hi all, Whole car is gone. Only have wheels left. PM me if interested. Cheers.
  2. Righto, whole car has been sold. Still have the wheels (Cpl.custard - please send me your mobile number and i'll send a pic of the wheels), and still have the full set of floor mats. Cheers, Ian.
  3. ECU, tail lights, front right drive shaft, boot seal and a couple of other bits GONE! everything else still available!
  4. I have this if you still need it. PM me if interested.
  5. I have an RS4 (not RS4S) computer if interested. $200 posted? PM me if interested please.
  6. RWD or AWD? I have complete AWD engine ready to go, Hobart area...
  7. I have a set of white Yokohama AVS Model 6's. 17x9, 2 tyres road legal, 2 tyres cooked. In hobart... PM me if interested.
  8. Wrecking, White 1999 Nissan Stagea. Factory Manual AWD with RB25DET Neo. 130,xxx km. These are a few specific things available: - $2200 RB25DET Neo AWD engine with about 130,000km (head gasket, timing belt, water pump etc were replaced at 100,000km - compression test to come, can hear running) - $600 Standard ECU with NISTune Type 2(?) board. - $600 Full set of R33 GTST brakes including 4 pot front calipers, 2 pot rears, non-warped rotors, good pads. Will not split anything. - $600 full set of white 17x9inch Yokohama AVS Model 6 wheels. one has slight gutter rash. Unsure on offset, maybe +35? Front tyres still have legal tread (Federal 595 EVO), rears cooked. (pictured) - $100/pair front guards, not rolled, mint condition. - $150/pair rear doors, mint condition, no rust, including glass and door trims. - $200 Series 2 tail lights and garnish, mint condition. - $150 Manual dash cluster with 130,000km, mint condition. - $80 climate control unit, mint condition. - $350 3 inch mandrel bent mild steel exhaust with stainless Varex muffler with twin tips (no controller). might suit other cars. - $400 standard RB25DET Neo turbo (OP6 rear), holds boost fine, never boosted past 10psi. - $20 hot side front mount intercooler pipe, alloy. - $80 standard AFM (slight damage, does not affect use). - $150 tail gate including glass. mint condition, good gas struts, no wing or lights/garnish. - $50 bonnet gas struts, excellent condition. - $400 rear subframe, including hicas, viscous(?) diff, pump, etc, never had any issues (can separate diff and sub frame). - $80 full set of floor mats. passenger side slightly worn, rest are mint. - $50 rear bumper bar. standard, mint condition. - $60 Turbosmart boost gauge, PSI up to about 20 or 25psi. - $50 3 inch stainless decat pipe. - $offers dash, no cracks or fading. mint condition. - $80 ~350CCA battery (exide brand, maybe), couple of months old. Was $150 new. Everything else available EXCEPT the following (THESE ARE NOT AVAILABLE): - Complete Manual conversion (gearbox, pedal box, clutch, clutch master and slave cylinders, hydraulic line, flywheel, tail shaft, front prop shaft). - Front doors - stock airbox - torque split, volts and boost gauge (factory) - front struts (standard all round) - front seats - cargo blind - cargo net (never had it) - steering wheel (air bag deployed) - headlights - indicators - front bar and rio, radiator, clutch fan, shroud, alternator, bonnet.(destroyed) - stereo... Prices are firm. Items located in Hobart. Can post smaller items at your expense. Items listed elsewhere also. Can provide pictures upon request of most, if not all items.
  9. I'll take the rotors. P.S: It's Davo...
  10. Pulled the head off my Stag on the weekend. Did the head gasket. Not sure what happened. It's an RS4(S?) with 103,000km on the odometer, but I think it's been wound back somehow. Blew the gasket on cylinder 6 into both the oil and water galleries, and it was starting to let go on cylinder 5. As soon as the temp gauge started to rise, I pulled over and had it towed. Fingers crossed the bearings are fine, as the oil is quite milky. Planning to have it back together this weekend coming providing parts and head machining aren't delayed!
  11. I think Skit might have some of these.
  12. Spotted a black C34 on Maquarie Street this morning at about 7:45-ish. Looked mint!
  13. Spotted a back C34 on Maquarie Street in Hobart this morning (7:45-ish). Looked so tidy !
×
×
  • Create New...