Jump to content
SAU Community

skylinebey

Members
  • Posts

    12
  • Joined

  • Last visited

  • Feedback

    0%

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

skylinebey's Achievements

Apprentice

Apprentice (3/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. Thanks i live on an island , finding mechanics that specialize in just brakes is difficult. So you learn how to do things yourself. I practice safety that is why the car has been parked for almost a year now. I will not drive it until this issue is resolved the right way. I have a brake vacuum kit to assist with the bleeding of the lines. I have a software to run diagnostics on the car I will see if it has the ABS troubleshooting. I will try as you recommended. Thanks again, like I said earlier specialized is hard to find. I appreciate the time you took to help me.??
  2. Thanks for your help replying. I was hope someone else can get further insight into the ABS brake bleeding. regards
  3. What is the proper procedure bleeding with a dry ABS? Thanks.
  4. The old caliper had a frozen piston and rusted . I cleaned up the piston and resealed that caliper and the brakes became spongy. So I then replaced with the bigger Gtt calipers and Pedal was still spongy? I then checked the Gtt caliper to see if there was a leaky seal. The was no leak. But still spongy , Then I thought the larger caliper working with the original MC was causing the spongy . So thats how I got to the MC being the problem... because it happened when the Orignal caliper went bad. I even replaced the ABS unit. Still same response.
  5. I have replaced the original calipers with the upgraded calipers from the R34GTT model mines was the GT NA.
  6. Thanks, This is my second refurbished MC from eBay and same result. I tried the mechanics here and they don't have any repair kits. So I will have to look on eBay for a resLeeve kit. Does the brake booster go bad? If so, how to I check ? Thanks again
  7. Hello, I have a R34 GT and my brake pedal has no pressure. I have replaced my master cylinder with a used one from Ebay and same result. When I pump the brakes it hold pressure for a few seconds with car on. I can only find refurbished parts, is there a way I can use new brake master cylinder from another vehicle?
  8. I already have the RB25 engine, it is not in the car yet.. I paid $4,000 for the car, so I thought it would be a good project. Also importing into the country we pay 75% on the purchase cost if the engine is 2.5 and above.
  9. Hello, I am upgrading my 2000 non-turbo R34 GTT, and I have a few questions. What brake calipers are recommended ? not Brembo (too expensive) should I use the brakes system for another R34 turbo car. Best Regards,
  10. The front passenger side brakes starting smoking today because of the heat that was produced from the brakes not releasing. The caliper is moving ok, Is the ABS the issue? What type of scanner do I use to read to codes? Any ideas ? Thanks..
×
×
  • Create New...