-
Posts
17,650 -
Joined
-
Days Won
6 -
Feedback
0%
oweban last won the day on September 5 2017
oweban had the most liked content!
About oweban
- Birthday 15/06/1984
Profile Information
-
Gender
Male
Recent Profile Visitors
12,523 profile views
oweban's Achievements
-
Awesome! Do you remember the brand? If not I’ll just dig through their shelves until I find one safe for plastics. But great to know someone has been successful!
-
oweban started following Paint removal
-
I’ve recently picked up a 33 GTR front bar as part of the ongoing collection of parts for the GTST>GTR conversion I’m stupidly doing - but I want to get the lip back to raw plastic, no paint, without damaging the plastic underneath. There’s a few things I’ve seen around - Aircraft Paint Remover (US only it seems), some graffiti remover (So Safe yellow label), but I’m not sure if there’s a better way to be doing this. Some of the paint is already spiderwebbed from impact I believe, so hopefully that helps? Open to suggestions. I know I could just paint it black, but it wouldn’t be the same.
-
Help; car wont start (and its not the starter)
oweban replied to ausdrift's topic in General Maintenance
Disconnect fuel filter at bottom end so it's just a hose from the back of the car (note - you'll get fuel over the place so be prepared) - have someone keep an eye on the hose when you crank it. If nothing, fuel pump (or relay/fuse) is gone. I had the same thing, did that, no fuel movement when cranking. New fuel pump with relay mod, bam back in business. If fuel comes out, then spark is bad - either coilpacks (or igniter if s1 but I think you're saying it's an s2), or plugs themselves. Last ditch effort, get a stock ecu just to test. Plug in, crank, if it works, then there's your problem. -
New to Skylines, Need Assistance
oweban replied to AusFreak's topic in RB Series - R31, R32, R33, R34 (1986-2002)
Idling issues - AAC valve usually, or a vacuum leak. https://www.sau.com.au/forums/topic/110431-diy-aac-valve-cleaning-idle-reset/ And yep, 22 year old cars will do that - be a pain in the arse forever [emoji4] Also clean the airflow meter, make sure it's not covered in gunk: https://www.sau.com.au/forums/topic/18037-how-to-clean-your-afm/ -
New to Skylines, Need Assistance
oweban replied to AusFreak's topic in RB Series - R31, R32, R33, R34 (1986-2002)
If you've got a gtst, one turbo; if a gtr, two, unless you swap back to a single setup. If you want to run more than 1bar you'll definitely need non-stock turbo, and then ECU, fuel pump, injector upgrades too (depends how far you want to go though). -
New to Skylines, Need Assistance
oweban replied to AusFreak's topic in RB Series - R31, R32, R33, R34 (1986-2002)
Ah - okay, maybe I should have read that. I just kinda went "f**k it" on it. Not a bad idea. Will change the pos next time I'm at the car. -
New to Skylines, Need Assistance
oweban replied to AusFreak's topic in RB Series - R31, R32, R33, R34 (1986-2002)
Relay mod effectively just gives the fuel pump full voltage from the battery but only when something else is on - I used the + line on fuel gauge sender as trigger. Cost me about $15AUD in parts and half an hour of sketching it up -
New to Skylines, Need Assistance
oweban replied to AusFreak's topic in RB Series - R31, R32, R33, R34 (1986-2002)
Hmm - I can't vouch for either of those brands, might need to research them a bit. Apparently s1.5 uses the same pack as s2. The leads is a loom that goes from the igniter to the packs - without the cover it looks kinda like this: http://s148.photobucket.com/user/dansVspec/media/Mobile%20Uploads/20131231_200614_zps1cba334f.jpg.html -
New to Skylines, Need Assistance
oweban replied to AusFreak's topic in RB Series - R31, R32, R33, R34 (1986-2002)
Oh coilpacks! If you're not chasing tons of power, check out splitfire or yellow jacket coilpacks. The leads from the igniter itself should be fine. For splitfires, dis-005 http://justjap.com/splitfire-direct-ignition-coil-packs-sf-dis-005.html Water pump and mishimoto radiator is a good idea, I just bought a mishimoto myself Enjoy the car stock for a while and then look into the upgrades -
New to Skylines, Need Assistance
oweban replied to AusFreak's topic in RB Series - R31, R32, R33, R34 (1986-2002)
https://i.pinimg.com/originals/c5/69/67/c569672602a4b1b5d55add9d69bb1ad0.png ^ VIN is located where the blue plate is there. Depends on what 33 you got, but should start with ECR33, HR33, ER33 - that kind of thing. The compliance sticker will have import info too, eg mine is 69U000ECR33xxxxxx. Coilovers - wayyyyyy too many options. Everyone will have their own opinion; I'm running the basic BC Racing ones from justjap and am pretty happy with them. -
then you can go and do dumb things like getting brand new GTR rear guards and getting them retrofitted... _looks at self sadly_
-
Without a boost controller the solenoid will lock it off anyway Unless f**k the solenoid f**k the IWG open that bitch up and baaaaang
-
Probably true - I don't know anything about hyper gear so can't really speak for or against them