Jump to content
SAU Community

285/30/18 Bridgestone Re55S, 295/30/18 A050 Soft, 255/40/18 Ad08


Recommended Posts

Hey Guys

I have a couple of sets of 285/30/18 Bridgestone RE55s available.
These are brand new, old stock. 2010 dated. Has been stored at Bridgestone until they cleared out the last of their RE55s.

They are the SR2 Compound (medium)

$250 each

Available for pickup from our shop in Bayswater, Vic

Can ship Australia wide. Adelaide or Sydney, $65 Brisbane - $80, Perth $120

Send me a message with your postcode for a quote elsewhere.

-----

Used 295/30/18 Yokohama A050 - soft compound.
This is time attack/hill climb type rubber where you need it grippy from the get go.
2012 dated and still very fresh. Quite a bit of tread left. $700 the set (close to what a new set would cost PER TYRE!)

--------

Brand new 255/40/18 Yokohama AD08

These are 2012 build

I have six available at $250 each - probably the best bang for buck street tyre

Good option if you were looking at a 265/35/18 as these are as wide as most 265/35/18

---------

post-58515-0-71048400-1404696248_thumb.jpg

post-58515-0-00839200-1404696250_thumb.jpg

post-58515-0-44511800-1404696251_thumb.jpg

post-58515-0-79094300-1404696252_thumb.jpg

post-58515-0-46698400-1404696464_thumb.jpg

post-58515-0-17820500-1404696466_thumb.jpg

post-58515-0-55951900-1404696467_thumb.jpg

post-58515-0-16114100-1404696469_thumb.jpg

post-58515-0-70647000-1404696470_thumb.jpg

post-58515-0-21380300-1404696472_thumb.jpg

Link to comment
Share on other sites

 Share



  • Latest Posts

    • Because it's rubbish, it got progressively better with each generation but still rubbish when you're pushing the car on the track. Some like it, most hate it.
    • Yeah, I presumed that the pic was of some other car, because of the F. Ikeya arms.
    • Did a little bit this afternoon and pulled the dump and turbo off so I could take the mani off to clean it up and give it a few coats of paint. Wire wheeled what I could get to and then got the sand paper out to get the tight spots. Gave it one coat so far, will do another two tomorrow and see if I can fit it in the oven to bake it for an hour along with the adapter and dbw.  Hoping the exhaust wrap I ordered turns up soon so I can wrap the dump and screamer. Ordered 30M so I'll wrap back as far as I can to help a little with temp next to the box and also the floorpan. 
    • Yeah I think overall I’m running the expected power I should be running for now and I’ll just enjoy it for the time being until I get some other parts. Thanks for the advice mate I appreciate it!
    • That's fair enough.  Might be time to just enjoy what you have until you sort the ecu/flex sensor situation. You can pretty much guarantee that you are knock limited and e85 is going to be the solution to more power. 
×
×
  • Create New...