Camshaft For Bnr32 Rebuild

[Godzira83]

Hey Guys,

I am rebuilding my BNR32 RB26 motor. I am doing a ground up rebuild from crank up. I am going fully forged pistons with billet conrods etc etc, im not taking any shorcuts but what i need help with is the camshaft. I would like to get a slightly lumpy note can someone give me an idea of which one to get with a reasonably stock head. I have heard the Tomei Poncam 260 degree with 9.15 lift is the way to go as they are a drop in fit? and allow enough room for valve clearance etc.

I truly have no idea about the cams so any feedback is appreciated. I do not want to spend a fortune on cams as i have spent ALOT of money already. Will i need to buy new lifters and springs also?

Thanks!

[GTRsean]

Poncams will drop straight in. Nice lumpy idle.

Just have to check valve clearances and adjust shims as necessary.

[Godzira83]

thanks GTRSean so the 260 degree cams are the ones i want? 9.15 lift? hopefully theyre not too expensive? and will i need to buy new lifters and springs? sorry for all the questions as cams are quite technical and out of my knowledge