Jump to content
SAU Community

Surprise Modifications


ausdrift
 Share

Recommended Posts

I was under the car on the weekend and got a little surprise. Ive owned the car for 2.5 yers now and only just noticed that I have a JIC front swaybar. I knew i had the rear one as its adustable and looks aftermaket, so it was a bit of surpised to find one on the front too Even more so as its nothing much to look at and i was considering swapping the front for a new one anyway as its a bit spongy.

So what parts have surprised you? What has a previous owner installed on your car that you didnt know about?

Link to comment
Share on other sites

Well not on my car at all... Was working at a garage for a while and a taxi came in complaining that the engine was knocking and felt odd.

He only had 1 engine mount.... Save weight?

Link to comment
Share on other sites

hahahaha you already have a nismo kit. not to mention, panda r34?

I collect those kits LOL. Just in case i write my car off again. Should PM before admins chew us out for being off topic

Link to comment
Share on other sites

haha well i know who to go to if i need parts ^^

back OT: not sure if this counts but previous owner told me i had apexi BOV, one day i finally figured out where/what my BOV looked like and realised it's a blitz. seems like previous owner had a thing with blitz, other parts are blitz too.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share




  • Similar Content

  • Latest Posts

    • Picked my tailshaft up yesterday arv!! Test fit it and because they've gone to a ford centre bearing and CV I had to modify the mounting bracket a little bit. 5mm of each side and she went up into position and fits well. It has a 1350 uni and flange on the gearbox end so it should be plenty strong!  Got stuck in this morning and started on the wiring mess. Cut out all the wires not required that go to the body connector and cut the engine harness out. Need to go through and work out which ones I need to keep and rewire into the new ecu. Should save a small amount of weight as well. I'd love to get in and rip the dash and everything out to completely remove wiring but cbf.  Next up was the power harness for alternator, starter etc. It has a few connectors from factory that run out of it. Cut it all apart and removed what was no longer required and put some new corro and taped it all back up and bolted it all back into place.  After that I worked out where I can mount the new flex sensor. Found a couple of factory bolt holes and drilled a new hole on the bracket to suit. Need to go get a few fittings and adapters tomorrow so I can keep going.   
    • Nah, im after the more newer looking, one with the OLED display
    • We revised the neutral wire instructions. The old way was wrong.  R34 gearbox change.pdf
    • Thanks for everyone's reply, I'll make some calls after the weekend. Really appreciate the help on this forum!
    • The MAF isn't even used to get the engine to crank over. It's only looking at RPM and coolant temperature if I recall the Nistune documentation correctly.
×
×
  • Create New...