Jump to content
SAU Community

New Genuine Bosch / Jecs Z32 Air Flow Meter Afm - $285 Incl. Delivery


Recommended Posts

GENUINE Z32 AIR FLOW METER

- Large 80mm diameter - most common AFM upgrade

- Genuine BOSCH/JECS - manufactured in Japan
- Wiring diagrams also available on request
- Can also supply TOMEI Plug $40 w/ wiring OR BOSCH Plug $30 w/ no wiring.
- OEM # 22680 30P00 (VG30DETT engine)

$345 $285 incl. Delivery >> SAU Special

BUY_BUTTON.gif

* This is an Australian delivered product with a full national warranty.


AFM-029_400.jpg


AFM-029_box.jpg

Link to comment
Share on other sites

  • 3 months later...
  • 2 weeks later...
  • 1 month later...

deilvery to sydney 2763 with plug to suit r34 in stock?

Hi,

Tomei Plug w/ wires would be $320 or BOSCH Plug w/ no wires would be $310 both incl. delivery.

Being a larger AFM then the stock 70mm one some modifications will be required.

- Brendan

Link to comment
Share on other sites

  • 1 month later...
  • 6 months later...
  • 1 month later...

So the tomei plugs have wires that have to be cut/soldered into the original afm wires, and the for the bosch connectors you have to undo the wires from the original connector and push them into the bosch one?

Hey!

Correct the BOSCH plug comes with no wires and the Tomei unit comes with wires. In most cases the Tomei one is an easier choice to work with.

- Brendan

Link to comment
Share on other sites

  • 3 months later...
  • 11 months later...
  • 2 weeks later...
  • 10 months later...
 Share



  • Latest Posts

    • Because it's rubbish, it got progressively better with each generation but still rubbish when you're pushing the car on the track. Some like it, most hate it.
    • Yeah, I presumed that the pic was of some other car, because of the F. Ikeya arms.
    • Did a little bit this afternoon and pulled the dump and turbo off so I could take the mani off to clean it up and give it a few coats of paint. Wire wheeled what I could get to and then got the sand paper out to get the tight spots. Gave it one coat so far, will do another two tomorrow and see if I can fit it in the oven to bake it for an hour along with the adapter and dbw.  Hoping the exhaust wrap I ordered turns up soon so I can wrap the dump and screamer. Ordered 30M so I'll wrap back as far as I can to help a little with temp next to the box and also the floorpan. 
    • Yeah I think overall I’m running the expected power I should be running for now and I’ll just enjoy it for the time being until I get some other parts. Thanks for the advice mate I appreciate it!
    • That's fair enough.  Might be time to just enjoy what you have until you sort the ecu/flex sensor situation. You can pretty much guarantee that you are knock limited and e85 is going to be the solution to more power. 
×
×
  • Create New...