Jump to content
SAU Community

Crd Shell 100 Testing


CRD
 Share

Recommended Posts

Hey Guys,

Here is dyno sheet of a R33 GTR with a new engine we built with R34 N1 turbochargers with before and after of 98 and 100 octane shell fuel.

Car is used for circuit only.

CRD

post-20527-1132266399.jpg

Edited by CRD
Link to comment
Share on other sites

Question:

You guys say that the car needs to be re-tuned if you use the 100RON fuel right? If not it may/will cause damage due to the engine running too lean?

My question is how you get the car to the tuner once you fill the car up with this stuff (100RON)? Granny it to the tuner? Obviously I'd need to drive around to burn off the excess non-100RON fuel first right?

Link to comment
Share on other sites

For those too lazy to click on the link

Coles Express Dickson Cnr Antill & Badham St Dickson ACT

*Coles Express Carlton 277–281 Princes Hwy Carlton NSW

*Coles Express Darlinghurst 47 Flinders St Darlinghurst NSW

*Coles Express Dundas Cnr Kissing Point Rd & Kirby St Dundas NSW

Coles Express Fairfield Cnr Polding St & The Horsley Drv Fairfield NSW

Coles Express Green Valley Cnr Cowpasture Rd & Green Valley Cartwright NSW

Coles Express Hurstville 39 Forest Rd Hurstville NSW

Coles Express Kingsford 48–56 Gardeners Rd Kingsford NSW

Coles Express Kirrawee Cnr Princes Hwy & The Boulevard Kirrawee NSW

Coles Express Lidcombe 18 Parramatta Rd Lidcombe NSW

*Coles Express Marsfield Cnr Epping Rd & Culloden Rd Marsfield NSW

Coles Express Neutral Bay Cnr Ben Boyd Rd & Ernest St Neutral Bay NSW

Coles Express North Ryde Wicks 96 Wicks Rd North Ryde NSW

^^^^^^Places listed on Shell.com as stocking 100 Optimax^^^^^

Link to comment
Share on other sites

My 0.02c: not enough places stock 100RON fuel to make the effort (and cost) to retune for the time being*.

A question for Jim: if you tune for this new fuel, what do the AFRs look like when you stick 98 back in (without altering the tune again)? I would assume rich, but how much extra timing (if any) did you wind in?

* For me, anyway. None of the petrol stations are anywhere near me, and the last thing I want to have to do is drive around like a granny looking for a Shell stocking 100RON fuel.

Link to comment
Share on other sites

i wouldnt get it tuned for that just for the fact that u cant get the fuel from many places, so if you go for a nice drive out to a small town of something, you wont get the right fuel. ok for a race car or something you never drive far.

Link to comment
Share on other sites

Problem with that midnight is you would get a mix of 100RON and 98RON and have a crossover period.. but that's about it..

What about running it in a Stock R33 - resetting the ECU - they run rich as they are - but would the timing need to be changed?

Link to comment
Share on other sites

That is right but if you use it you need to retune the engine as the 100 uses 2 percent oxygen

Shouldn't that statement be:

"To make the same power (as 98) with 100,and have the correct mixture, you need to retune the engine as the 100 uses 2 percent more oxygen therefore the engine will run leaner." or something like that :P

Please correct me if I'm wrong, Jim. Putting 100 in a car tuned to run on 98, 95, or 90 will not make the engine run leaner, it just wont burn all the available fuel.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • This is the part I was unprepared for. I mean, thinking about it now, the first day I collected my car from the importer someone posted a photo of it on the highway to an online JDM page which my friend then sent me. I drove straight to the office to pick up some things and was immediately swarmed by about ten college kids -  "how much power" "why no wing" etc. The next couple times I went out I didn't really notice anything, there was a "why no wing" at a service area at some point. Then during the fourth time out driving at the Nurburgring I got the "do a drift" - the bastard cut it out in this clip. The title in itself is a red flag. As you may have guessed, I am not a fan of the attention. This leads me to wondering what to do with the car in the future; I'll see how this year goes and it may be garaged, which it mostly is already, or maybe even sent back to Japan  to also be garaged and driven occasionally on visits. Fortunately my daily is as interesting as drying paint.   
    • I couldn't get this to work right, New clean IACV, coolant seems to flow and solenoid functions, but again as soon as I plug it in the idle raises, I ran the car for a good 1/2 hour messing around with various things it, no vac leaks. At one point with the IACV plugged in I was able with the adjustment in the side of IACV turned all the way in get it idle down a little to around 1000, but no lower, and it would surge, I unplugged the IACV engine rpms drop to about 350, turned the adjustment about 3 turns in , set idle to around 800 rpms' and it idles smooth. I set the idle stop screw abut the same so it cant drop below under load. the engine starts, restarts, with no load or with a load seems to run fine. I will have to leave it like this for now as I cant get it to function correctly with the IACV plugged in. One other thing I discovered that might be the reason for some of the issues, the engine in the car is a RB25det neo from a Stagea along with the Stagea ECU. so alot of wiring, plumbing etc that is typically there in a R34 is not. 
    • Hi all, Trying to seek some assistance with my issue. I'm currently doing a complete overhaul of my suspension / driveline, on my r33 gtr and have completed stripped down the front assembly. I had purchased a new pair of front knuckles (the painted silver ones in the pictured) They were advertised by the shop aswell as other retailers online to be compatible with the entire 4wd R chassis, however when trying to fit the new pair, they don't line up with the ball joints (from the lower control arm) and the steering tie rod.  The other knuckle pictured is what came off the car, everything fits up to it perfectly, however I've been unable to figure what variant they are from originally.
    • What would be the best off set on 18" rims for these settings   
×
×
  • Create New...